VoIP GuidesContact us
← Back

Set a static IP address on a Fanvil phone

Give the phone a fixed address on your network.

Fanvil device

Only do this if your network needs it.

Steps

  1. In the phone's web page, go to Network → Basic.
  2. Change the IPv4 mode to Static IP.
  3. Enter the IP address, subnet mask, gateway and DNS servers.
  4. Apply and let the phone restart.
Tip: Write down the new address first.
More Fanvil guides

Set up a Fanvil GA10 or GA11 ATA

Connect an analogue phone, fax or alarm to VoIP.

AdminGA ATA series

Find a Fanvil ATA's IP address

Locate a GA10 or GA11 on your network.

AdminGA ATA series

Factory reset a Fanvil ATA

Wipe a GA10 or GA11 back to defaults.

AdminGA ATA series

Update Fanvil ATA firmware

Install newer firmware on a GA10 or GA11.

AdminGA ATA series

Use the second SIP account on a Fanvil ATA

Register a backup or second line.

AdminGA ATA series

Change the Fanvil ATA admin password

Secure the ATA's web page.

AdminGA ATA series

See all Fanvil guides